Page 1 of 2
Following a strict preventive maintenance program is essential to the health of your vehicles and your company. It can significantly improve resale value, save fuel, and often helps avoid breakdowns, which can be costly in so many ways.
While owner manuals, which map out timelines for everything from oil to transmissions, are readily available for most sedans, vans and SUVs, operators may not have such a convenience for their limousines.
Special severe duty editions can be helpful for building a maintenance program, but according to Kit Dickman, CEO of L.A. Limousine Repair Services in Hawthorne, Calif., severe duty schedules are often created for vehicles operating under optimal conditions (including highway driving).
Stop-and-go traffic, excessive idling and the kind of scorching temperatures operators face in states such as Arizona, Texas and Florida, make driving conditions less than ideal.
Limousines also come in many lengths and weights. The following schedule was created by Dickman for his clients, and is meant for newer limousines that have been stretched about 120 inches. L.A. services about 10 limousines each day.
Every 4,000 miles:
- Change oil. For synthetic oil, vehicles can wait until 8,000 miles.
- Check brake pads for wear. Change, if necessary.
- Rotate tires and check them for uneven wear and proper inflation. Uneven wear may result from a poor alignment. Improper inflation will cause decreased gas mileage.
- Check alignment if tires are wearing unevenly. Align, if necessary.
- Check belts, hoses and all fluid levels. Replace or fill, if necessary.
- Check drain holes in the rear corners of the moon-roof. Clean drain tubes with an air hose.
Preventive Check at 21,000 miles:
- Check transmission. If transmission does not need servicing, wait until 30,000 to clean, flush and replace with new fluid.
- Check the drive shaft for wear in the bearing, slip joint and u-joint. Check mounting bolts for tightness. Grease the u-joint and slip joint.
Every 30,000 miles:
- Replace fuel filter.
- Perform differential service, which requires removing the inspection cover and visually checking components. Operators may find a damaged clutch in the posi-traction, but it’s unlikely.
- Clean fuel injection.
- Check cooling system. If it’s working fine, wait until 60,000 miles and then flush it and replace coolant.
- Brake fluid exchange/flush. This is something many people forget to do, but it’s important. Brake fluid readily absorbs water. Any moisture in the brake fluid will lower the boiling point, which allows air into the system, causing brake failure. Brakes on limousines run hot because vehicles are so heavy. ABS brakes on newer cars are more susceptible to dirt and corrosion. When they get dirty, the brake module will not function. The only cure is replacing the ABS module once it fails. Brake fluid should be honey-colored.
- Air conditioning maintenance. Make sure the condenser, located in front of the radiator, is clean and has good air flow. Remove the plastic cover on the engine, take a garden hose and flush out the front of the condenser and the front of the radiator. Put a thermometer in the vents and use a temperature probe to check air coming out of the evaporator. In 90-degree weather, the air should be 50 degrees coming out of the rear vents at idle. Front vents will be four to seven degrees cooler. While riding down the road, the temperature should drop another seven to eight degrees. Check high-side and low-side pressure. At a fast idle in hot weather, you should have about 220 pounds on the high side and 22 to 30 pounds on the low side. Often, there is too much freon. Remove excess freon so the air conditioner will perform more efficiently.
- Change air filter.
To help prevent breakdowns and ensure that clients always get a vehicle in pristine condition, Arrow Limousine in Red Bank, N.J., requires all vehicles undergo a quick inspection before hitting the road. According to Eddie Somers, Arrow’s vice president, every vehicle is checked for appropriate levels of oil and washer fluid. This is particularly important during harsh summer and winter months. Chauffeurs are asked to do a “walk around” to check tire inflation or note any body damage, scratches or parking lot dings.
Listen to Your Vehicles
Make sure chauffeurs report any rattles, clunks, squeaks or mechanical noises, so you can catch small problems before they become expensive ones. The following is a list of “strange” noises and their probable causes:
- Buzzing is generally a vibration of a loose fascia, vent, knob or wiring connector rattling against ductwork. Debris in ductwork also causes buzzing. High-pitched buzzing from under the vehicle can mean the heat shield on the catalytic converter is loose.
- A metallic-sounding clicking noise that speeds up as the throttle is applied may be caused by a bent or loose fan blade hitting the radiator or protective shroud. This is especially true on older vehicles with metal fan blades.
- If it’s not just a loose item in the trunk, a heavy, metallic clunking or thumping noise that occurs when the vehicle is put into gear on a rear-wheel drive vehicle, may be a failing universal joint on the drive shaft.
- Metallic grating or grinding sounds that occur when brakes are applied means worn brake pads or shoes.
- On older vehicles, a growling sound coming from the engine can mean crankshaft bearings are worn or may indicate rear-end problems.
- Hissing that sounds like air escaping could be a tire puncture or loose valve stem. Escaping steam from a blown radiator hose also hisses. When checking for steam, open the hood carefully to avoid steam burns.
- A metallic knocking sound like a hammer hitting a metal door could mean worn piston rod bearings, allowing the piston rod to knock against the inside of the engine, destroying it in minutes.
- If the engine makes pinging noises that sound like loose gravel in a tin can, you probably have pre-ignition, a condition caused by improper timing or using the wrong octane fuel.
- Rattles can be caused by anything from a loose jack handle in the trunk to a broken or a loose shock. Check for loose items before seeing the mechanic.
- Most squeaks are in the suspension system and are caused by a combination of road dirt and a lack of lubrication. Pressure wash the suspension and get a lube job. Spraying door seals with a Teflon lubricant will usually cure squeaking doors.
- A loose drive belt can cause a high-pitched squealing or screeching under the hood. If the sound happens as the brakes are applied, the wear indicators are telling you the pads are worn.
- A light metallic tapping or ticking sound may mean that the valves aren’t getting proper lubrication or need adjustment.
- A whirring, whirling sound may indicate pending automatic transmission trouble.
- Caused by disturbed airflow around the vehicle, a whistle can be difficult to pinpoint. Anything from loose molding, an antenna, mirror, roof rack or slightly open window can cause whistling.